32mm Multiwall Polycarbonate | The Polycarbonate Store 32mm Multiwall Polycarbonate | The Polycarbonate Store

Showing all 5 results

32mm Multiwall Polycarbonate


Why has 32mm become less commonly specified since the introduction of 35mm sheets?

35mm has become the standard for new conservatory roofs because it insulates a little better, so most new specifications now call for it. We still stock 32mm because it is the size fitted in many existing conservatory roofs, and glazing bars and end closures are still made for it. It is not discontinued. If you are replacing panels, match the thickness already fitted.







Is 32mm mainly used now for replacing sheets in an existing conservatory roof?

Largely, yes. Many conservatories built with polycarbonate roofs use 32mm sheets, and the glazing bars, end closures and tapes on those roofs are sized for it. Replacing like for like keeps everything fitting properly. For a new roof most people choose 35mm, though 32mm still works well and the difference in insulation between the two is small.







What's the maximum recommended unsupported width for 32mm sheets on a rafter-supported roof?

We recommend a maximum sheet width of 1000mm for 32mm multiwall without extra support. The manufacturer allows wider spans at light loads, but 1000mm is the safe figure for a DIY roof. Sheet width is not a guarantee of a sound roof, so check your wind and snow exposure, or call the technical team before you order.







Are 32mm sheets available in the same heat guard and dual-tone options as 35mm?

Yes. We stock 32mm in the same five finishes as 35mm: clear, bronze, white opal, bronze/opal dual colour and opal heat guard. That means you can replace a single tinted panel in an existing 32mm roof without changing the look of the rest. Check which finish is fitted before ordering, because bronze and bronze/opal both look bronze from outside.







How is the correct orientation identified when installing a 32mm multiwall sheet?

The printed protective film marks the UV-protected face, and that face goes towards the sun. Leave the film on until the sheet is in position, then peel it off. Run the flutes, the hollow channels inside, down the slope so condensation drains to the bottom edge. Fitted the wrong way up, the sheet will yellow and crack within a couple of years.







What are pre-taped edges on multiwall polycarbonate sheets?

What are pre-taped edges on multiwall polycarbonate sheets?

Pre-taped edges mean that protective tapes have already been applied to the open ends of your multiwall polycarbonate sheets before delivery, saving you time during installation.

At The Polycarbonate Store, our complimentary pre-taping service is available on 10mm, 16mm, 25mm, 32mm and 35mm twinwall and multiwall polycarbonate sheets.

The two open ends of the sheet's hollow channels (flutes) are taped differently:

  • Top edge โ€“ Aluminium sealing tape: Solid silver tape seals the upper end of the flutes, helping prevent water, dirt and debris from entering.
  • Bottom edge โ€“ Anti-dust breather tape: Helps prevent dust and insects from entering while allowing ventilation and moisture to escape, reducing the risk of condensation build-up.

For a standard sloping roof, the aluminium-taped edge must be positioned at the top, with the breather-taped edge at the bottom, towards the gutter. The tapes should remain in place during installation.

Important: Pre-taping only covers the two open flute ends, not all four sides of the sheet. It does not replace the need for PVC sheet end closures, which should be fitted over the taped edges to provide additional protection and a neat finish. Pre-taping also does not completely prevent condensation.

During preparation, approximately 10mm of protective film is removed from each taped end. This may leave a visible preparation line, which is normally concealed by the roofing accessories. If you need to trim a pre-taped sheet, the newly exposed flutes must be cleaned and re-taped correctly before installation.

For curved roofing or other applications, the required tape arrangement may differ. Please contact us before ordering if you are unsure.

For further information, read our full guide: What Do Pre-Taped Edges Mean on Multiwall Polycarbonate Sheets?







<<

1

>>