32/35mm Brown Aluminium F-Section
Our F-Sections come in a selection of lengths. Please use the drop-down menu below to view the lengths we have on offer.
These are only advised to be used directly onto the sheets with the extended side pointing down. Note that F-Sections are only powder coated on the outside.
If you install the F-Section with the extended side facing upwards and is positioned against a solid wall, it is recommended that you use flashing tape to seal where the accessory meets a brick wall.
This f-section can be used on its own to save costs but only if the extended side is pointing downwards so it can be screwed through regularly into the side of the rafter.
The aluminium f-section slides over the edge of your polycarbonate sheet. If used in this way, you will need to run a bead of silicone along to assist with waterproofing.
The aluminium f-section can be used with a self-support glazing bar to create an end bar.
Not to be used with a PVC capped glazing bar as the prongs are too deep, a PVC sheet closure can be used as an alternative.
- Easy to clean
- Easy to cut
- Easy to fix
- Light Weight
- Low Cost
- UV Stable
