SHEET CLOSURES

  • cover-white
  • cover-white_2
  • w1-w

SHEET CLOSURES CONTENTS

Sheet Closures are sometimes referred to as End Closures, Finishing Profile and U Trim.

Sheet Closures are used to finish the bottom end of the Polycarbonate Sheets when fitted to the roof.

It is essential that you use Sheet Closures on your Polycarbonate Rood as it forms a weather proof seal to the end of the sheets preventing Water Ingress.

Sheet Closures should be used at the lower ends (nearest the gutter) and can also be used for the top end if required.

BASIC INSTALLATION ADVISE:

Our standard length of Sheet Closures is 2100mm in length and will normally need to be cut down to size, to fit onto the ends of your sheets.

The Sheet PVC sheet closures can easily be cut with a hand saw or sharp blade.

When the sheets have been applied flat to the rafters / supports and secured down with Glazing Bars then simply slide the Sheet

Closure over the edge of the sheet, it is advised to run a small line of Silicon along the edge to ensure it is completely watertight.

STOCK INFORMATION:

  • We offer our range of Sheet Closures in colours of White and Brown.
  • We offer standard lengths of 2100mm in our Sheet Closures.
  • We supply an approved Silicon Adhesive that is suitable for our Polycarbonate Sheets and Accessories.
  • To purchase our Sheet Closures Click Here.

OTHER ACCESSORIES YOU MAY NEED

Please see below links to other accessories you may need for the installation of your Polycarbonate Roofing